Designer's Choice Perimeter System - cont.
Examples of specifications for one possible configuration of a run of the Designer's Choice
Perimeter System for retail store layout.

Download PDF of this page   |  All photographs of Retail Displays in Catalog ( zip file )
Download a .zip PDF file of entire 2008 Newood Catalog

Example of a run of Designer's Choice Perimeter System:
Drawing #1 (page 67) illustrates one of many possible configuration and combination of parts to create an attractive and versatile fixture run. Note that Headers are used in the center section only. Top Caps are optional when Headers are used and Headers are optional when Top Caps are used. Both Headers and Top Caps can be used for a heavier and more elegant look.

1. This run was designed with a combination of Upright thicknesses, depths and heights to add to the visual appeal.

2. Headers (used in center) usually match the moulding pattern applied to the front edge of the Uprights. Top Cap moulding is fabricated and precut for assembly onsite. See pages 79-82 [ 79 ] [ 80 ] [ 81 ] [ 82 ] for Top Cap moulding options. All units in Drawing #1 have optional Door Kits for overstock storage. In this run, two slatwall backs and five standard backs are used. The accessories shown are typical of most installations.

3. For each run we provide a layout drawing as illustrated in Drawing #2 (same configuration as Drawing #1). Upright location is identified by letters (A,B...). Installers match the letter marked on each Upright to the letter shown on the drawing (A to A) (B to B), etc... Below is a description of each upright.

*See pages 71 - 73 for Upright front moulding options. [ 71 ] [ 72 ] [ 73 ]

Drawing #2


A - Left end Upright: 3" x 18" D x 82" H. Moulding Pattern 3P2 (1)
B- Inside Upright: 3/4" x 18" D x 82" H. 1-3/4" Moulding Pattern 2P2 (2)
C- Left Transition Upright: 6" x 22" D x 92" H. 6-1/2" Moulding Pattern 6P2 (1)
D- Inside Upright: 3/4" x 22" D x 92" H. 1-3/4" Moulding Pattern 2P2 (2)
E- Right Transition Upright: 6" x 22" D x 92" H. 6-1/2" Moulding Pattern 6P2 (1)
F- Right end Upright: 3" x 18" D x 82" H. Moulding Pattern 3P2 (1)

Drawing #3

All Top Cap moulding is sent with a 3" horizontal back plate attached. Parts are precut to exact angles and lengths ready to be installed. Each Top Cap part is marked with a number (1,2,3, etc.). At the site the installer matches the part number to each number shown on the Top Cap layout.

* See pages 79-82 [ 79 ] [ 80 ] [ 81 ] [ 82 ] for moulding pattern options.

68   Designer's Choice Perimeter System